Pls Help : Kodak HIE and Ilford DDX

Runz

Member
Joined
Mar 19, 2006
Messages
6
Location
Singapore
Format
35mm
Hi,
I just shot a roll of kodak HIE and was wondering if anybody tried to develope it with Ilford DDX. I was not able to find any information about this combination. Thanks!
 
Last edited by a moderator:

pentaxuser

Member
Joined
May 9, 2005
Messages
20,059
Location
Daventry, No
Format
35mm
Runz. I have 2 books on infrared and neither mention DDX in their development section. Hopefully someone has tried it and will reply.If you get nothing on DDX, I can tell you what both authors suggest for Kodak, if you indicate a desire to know.

Best of luck

pentaxuser
 

titrisol

Subscriber
Joined
Aug 2, 2004
Messages
2,072
Location
UIO/ RDU / RTM/ POZ / GRU
Format
Multi Format
DDX came to the market in 1999 or so. It is seldom talked to in books because of that.

However, is HIE behaves like a 200 speed film 7.5-8 minutes should be more in the ballpark.
If you can run a test first
 

lowellh

Member
Joined
Mar 22, 2004
Messages
67
With Clayton F 76 chemistry, which is very similar to DDX, I recommend that the HIE films be developed the same as Tri X or HP 5.
 
OP
OP

Runz

Member
Joined
Mar 19, 2006
Messages
6
Location
Singapore
Format
35mm
Hi,
Thanks for the recommendations. Think i'll send this roll to the lab for now, as this is a exposure test roll to begin with, i dun wanna add more uncertainty when analysing the results. Maybe i wll experiment with DDX when i get the exposure right. THANKS!
 

Dracotype

Member
Joined
Jan 4, 2006
Messages
62
Location
El Cerrito,
Format
Medium Format
I would be cautious of sending your HIE to the lab. If the staff doesn't know much about IR film, you could get some nasty results.

Another point I would make is that everyone comes up with a personal combination of developer and EI that suits their style with infrared. In the case you are talking about, you will be optimizing for your EI, but the lab's developer. You have less control over that. If you ever want to use DDX with HIE, I would not start by sending your first roll to the lab. Optimize your developer time with your personal EI. HIE is finiky, and everyone manipulates in differently. The variations in developer/EI are much more obvious than with any other film. I would do it myself. Personally. But do not let me discourage you from using HIE. I love the stuff. It's just that I have had bad experiences with lab techs ruining my film. Good luck on that.

Drew
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…