pink shade when film is wet

ashokgoyal42 · Feb 21, 2011

Hi,

I've developed Kodak/Fuji 400/800 film with my Tetenal kit. Since the last two times I've noticed the film has a pink cast when I take it out of the stabilizer and hang it. When the film dries the pink cast disappears. In fact even while drying the edges turn that amber brown as the film drains off the water.

Just wondering whether this signals something wrong.

Ashok

hpulley · Feb 21, 2011

Just look when it is dry. If fine when dry then there are no problems.

John Shriver · Feb 21, 2011

Yeah, stabilizers can make film look weird when wet. I ran a roll of Ektachrome 200 (EPD) through C-41 Vericolor Stabilizer III today after having it cross-processed in C-41. (All E-6 films still need Formaldehyde stabilization, as do pre-2000 C-41 films.) The back side was an eerie blue-green, and the emulsion side was dark brown. Went away when it dried.

brucemuir · Feb 21, 2011

If by pink you mean a dull/cloudy look to the orange mask with C41 then it's completely normal and disappears as the film dries.

hrst · Feb 21, 2011

It's perfectly normal, and it's not because of stabilizer, I think it has something to do with refractive indexes; the dyes scatter light in a different manner when there is water in the film.

ashokgoyal42 · Feb 22, 2011

Thanks all, that's reassuring.

Ashok

pink shade when film is wet

ashokgoyal42

hpulley

John Shriver

brucemuir

hrst

ashokgoyal42

Privacy & Transparency

Privacy & Transparency