Old Question, 645 Pro TL Mirror Stop Replacement

[Ralphieboy]

I've searched a bit and not found one. Someone has been 3d printing them, any of you know where I can find one?

 

[Melvin J Bramley]

I've searched a bit and not found one. Someone has been 3d printing them, any of you know where I can find one?

Find someone with a 3D printer and steer them to this site; Yeggi lots of Mamiya stuff.

Please wait a moment while we check whether you are human or a bot. You will then be automatically redirected.

 

[Ralphieboy]

Find someone with a 3D printer and steer them to this site; Yeggi lots of Mamiya stuff.

Please wait a moment while we check whether you are human or a bot. You will then be automatically redirected.

Thanks! Downloaded and will find someone to print it tomorrow.

 

[Ralphieboy]

Find someone with a 3D printer and steer them to this site; Yeggi lots of Mamiya stuff.

Please wait a moment while we check whether you are human or a bot. You will then be automatically redirected.

Next question.... There are 2 listed. One just says Mamiya 645 the other says it's for the 645 Super. I think the Pro TL will use the one listed for the Super. Correct?

 

[MattKing]

I would think it would be this one:

The Pro and the Pro-Tl are very similar.

 

[Steven Lee]

Why not order from eBay?

https://www.ebay.com/itm/275225488704 <-- I ordered from this seller.
https://www.ebay.com/itm/384590277420 <-- I never tried this seller

 

[IMoL]

I have a couple of these left over from when I had a Mamiya 645 ProTL (printed by Shapeways in PA12 Nylon) which I will gladly send to anyone who wants them for the cost of postage (inside EU only).