Need instructions on how to replace light trap on A12 back

Eric Rose

Member
Joined
Nov 21, 2002
Messages
6,843
Location
T3A5V4
Format
Multi Format
If you have something you can email me or send me to a link that shows how, that would be great! Leaving in a couple of days and have 2 leaking backs. Sucks.
 

msage

Member
Joined
Mar 22, 2003
Messages
437
Location
Washington State
Format
Large Format
Eric
Replacing the trap is easy, getting the part is the hard part. If you have a source for the parts, let me know, please!
Michael
 

Amund

Member
Joined
Nov 18, 2004
Messages
902
Location
Oslo,Norway
Format
Multi Format
msage said:
Eric
Replacing the trap is easy, getting the part is the hard part. If you have a source for the parts, let me know, please!
Michael


Huh?????
 

fdisilvestro

Member
Joined
Nov 23, 2005
Messages
73
Format
Multi Format

Jim McD

Member
Joined
Dec 7, 2004
Messages
55
Location
New Hampshir
Format
Multi Format
Your problem is that you need to replace the seals in a few days-it takes longer to get them from Hasselblad USA than that by UPS. You want to buy them from Hasselblad, that way you know you're getting a good product.

They are simple to replace, 6 screws, pop out the old seals, put in the new seals, 6 screws and you're done.

As a temporay fix, pull your darkslide and cover the opening with black electrical tape. This will et you through the trip.
 

wjmva

Member
Joined
Jul 8, 2003
Messages
11
Be careful

About 1965 I replaced light seal on a Hassy back.

Let me tell you what I did wrong. The screws that you remove to get to the light seal look the same but they are not the same lenght.

You must keep them in the same location otherwise you will get a scratch down the entire 120 or 220 film.

As an expidient remove seal and bend longitudinally over a round pen or pencil to increase curvature. Once reassembled check seal with out slide and film holder by holing up to a strong light.
 
OP
OP

Eric Rose

Member
Joined
Nov 21, 2002
Messages
6,843
Location
T3A5V4
Format
Multi Format
thanks everyone. I took one apart last night and rebent the black plastic shield. I didn't realize the screws were different lengths?? Now you have me worried!

Now I just have to get the spacing issues addressed .....
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…