Magnet came off my Jobo !!!

lordvader

Member
Joined
Jun 17, 2010
Messages
47
Location
Melbourne, V
Format
35mm
Hey all !

So, I've been processing a lot of film with my Jobo CPE-2 (non plus). Lately, the magnet (on the jobo end) has been wobbling, and has finally fallen off (fortunately not mid-process).

What would be the best way to re-attach it ? Would super glue suffice, or should I go for an epoxy ?

Thanks
 
OP
OP

lordvader

Member
Joined
Jun 17, 2010
Messages
47
Location
Melbourne, V
Format
35mm
The thought has crossed my mind, but I assumed that something like that will be too flexible ...
I'm guessing you used the minimum amount ?
 

werra

Member
Joined
Mar 12, 2007
Messages
332
Location
Tallinn, Est
Format
Multi Format
No, generous amount, to fill all the gap on the side as well, not only backside. Just let it cure for 24hrs or so. Fixed two tanks ca year and processorside 2-3 months ago, nothing has gone loose since that.
Superglue and epoxy are hard and fragile, you can feel sealant flex just barely, but it's holding strong.
 
OP
OP

lordvader

Member
Joined
Jun 17, 2010
Messages
47
Location
Melbourne, V
Format
35mm
I ended up using a silicone sealant, which seemed to do the trick.
Gonna try it out tomorrow, when I have a go at C41 developing
 
OP
OP

lordvader

Member
Joined
Jun 17, 2010
Messages
47
Location
Melbourne, V
Format
35mm
I ended up using a silicone sealant, which seemed to do the trick.
Gonna try it out tomorrow, when I have a go at C41 developing
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…