Lindahl Dark Slide Holders for Hasselblad

epraus

Member
Joined
Apr 5, 2008
Messages
23
Format
Large Format
I bought three of these and am perplexed. Perhaps I am an idiot BUT when I slide the dark slide into the Lindahl they all fall apart leaving one part on the camera and two on the ground!!?? I am ready to rip them off and relegate them to the recycle bin. I saw nothing in the instructions about the use of glue.:confused:
 

Andrew Moxom

Member
Joined
Feb 2, 2007
Messages
4,888
Location
Keeping the
Format
Multi Format
epraus, they use double sided (extremely sticky tape) First clean the contact area on the rear of the back with alcohol. Then remove the protective cover on the three tape pieces , and place the holder onto the film back. Be sure to get it right because if you lift it back up, you can ruin the tape. It has to be right the first time. I did two without a problem.
 
OP
OP

epraus

Member
Joined
Apr 5, 2008
Messages
23
Format
Large Format

Thanks for the reply but the holder attaches with it's stick surface to my back. The Lindahl holder falls apart into two pieces leaving one piece on the back and the other on the floor.
 
Last edited by a moderator:

fschifano

Member
Joined
May 12, 2003
Messages
3,196
Location
Valley Strea
Format
Multi Format
So what you're telling us is that the holder is a piece of junk and that we shouldn't waste money on one?
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…