For Sale Lens Board Blowout

Trader history for Robert Ley (0)

Robert Ley

Subscriber
Joined
Jun 9, 2004
Messages
665
Location
Buffalo, New
Format
Multi Format
I have the following lens boards for sale

Linhof/Wista style boards made by Toyo:
many #0 boards $15.00 ea two or more $12.50 ea.
1 Toyo #3 board $25.00
1 Toyo #3 slightly enlarged and drilled for a flange $22.50

3 genuine Wista boards #0 $25.00 ea
2 genuine Wista boards #1 $30.00 ea

1 Linhof Technika Board drilled 2in./50mm $40.00

2 generic Linhof/Wista style recessed boards #0 $30 ea.

1 Silver Linhof Technika lens board that I believe is for the Tech III 2.5in/65mm hole and drilled for a flange $20.00

1 Cambo Recessed board #0 $25.00
1 Calumet/Cambo Board #0 $20.00
1Calumet/Cambo Board #1 $20.00

1 Sinar Board drilled 2in/50mm $20

The above prices are my best estimate, I might be off so I will accept reasonable offers and if you want multiples a deal can be made.

 
OP
OP

Robert Ley

Subscriber
Joined
Jun 9, 2004
Messages
665
Location
Buffalo, New
Format
Multi Format
Yes they are the 6"+ boards and are made for the Cambo/Calumet mono-rail view cameras.

also, many other boards remain.
 
OP
OP

Robert Ley

Subscriber
Joined
Jun 9, 2004
Messages
665
Location
Buffalo, New
Format
Multi Format
The two Cambo flat boards have been sold. Lots of Linhof/Wista style boards remain!
 
OP
OP

Robert Ley

Subscriber
Joined
Jun 9, 2004
Messages
665
Location
Buffalo, New
Format
Multi Format
Tony, I have many of the #0 boards left. They are Toyo boards, but fit my Wista VX like a glove and I feel assured that they would fit on your camera. I have already sent a couple of these boards to OZ, so shipping is not a problem. I also have a couple of Wista #1 boards, but at a slightly higher cost. PM me if you would like one or two of these boards. BTW shipping would be about $12.00
 

nigelsim

Member
Joined
May 14, 2012
Messages
3
Format
Large Format
Are there linhof/wista type copal#1 and #3 board with a notch?
 
OP
OP

Robert Ley

Subscriber
Joined
Jun 9, 2004
Messages
665
Location
Buffalo, New
Format
Multi Format
I have sold most of the boards that I had and of all the boards, none had a notch. I know the significance of the notched hole in the board, but frankly have never seen one or for that matter found a need for one. I have found that most lenses fit just slightly differently on each camera and I would not want to be limited in how I can place the shutter on the board. If it is important that you have a notch, then use a dremel tool and notch the board yourself. If there is a screw on the shutter that is not allowing the shutter to lie flat on the board, then remove it and move on. All of the lenses that I have had the screw removed long ago or never had one.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…