For Sale Lens Board Blowout

[Robert Ley]

I have the following lens boards for sale

Linhof/Wista style boards made by Toyo:
many #0 boards $15.00 ea two or more $12.50 ea.
1 Toyo #3 board $25.00
1 Toyo #3 slightly enlarged and drilled for a flange $22.50

3 genuine Wista boards #0 $25.00 ea
2 genuine Wista boards #1 $30.00 ea

1 Linhof Technika Board drilled 2in./50mm $40.00

2 generic Linhof/Wista style recessed boards #0 $30 ea.

1 Silver Linhof Technika lens board that I believe is for the Tech III 2.5in/65mm hole and drilled for a flange $20.00

1 Cambo Recessed board #0 $25.00
1 Calumet/Cambo Board #0 $20.00
1Calumet/Cambo Board #1 $20.00

1 Sinar Board drilled 2in/50mm $20

The above prices are my best estimate, I might be off so I will accept reasonable offers and if you want multiples a deal can be made.

 

[Robert Ley]

Two of the Toyo #0 boards have been sold!

 

[J. P.]

PM Sent

 

[Robert Ley]

Linhof board with 2" hole is sold...many more boards remain!

 

[henseman]

hi...the cambo, calumet/cambo boards....are they the 6"+ square boards?

 

[Robert Ley]

Yes they are the 6"+ boards and are made for the Cambo/Calumet mono-rail view cameras.

also, many other boards remain.

 

[Robert Ley]

The Cambo recessed board has been sold!

 

[Robert Ley]

The two Cambo flat boards have been sold. Lots of Linhof/Wista style boards remain!

 

[Robert Ley]

The Toya #3 board with the enlarged hole is sold!

 

[Robert Ley]

1 ea of the Wista boards are spoken for. Lots of boards remain!

 

[Robert Ley]

One of the Toya #0 boards has sold and shipped...lots more where they came from

 

[Robert Ley]

Many more of the boards are still available. You know you need one

 

[tony lockerbie]

Any Linhof 0 boards left?

 

[Robert Ley]

Tony, I have many of the #0 boards left. They are Toyo boards, but fit my Wista VX like a glove and I feel assured that they would fit on your camera. I have already sent a couple of these boards to OZ, so shipping is not a problem. I also have a couple of Wista #1 boards, but at a slightly higher cost. PM me if you would like one or two of these boards. BTW shipping would be about $12.00

 

[Toan]

PM sent

 

[bkarasek]

bump

 

[nigelsim]

Are there linhof/wista type copal#1 and #3 board with a notch?

 

[Robert Ley]

I have sold most of the boards that I had and of all the boards, none had a notch. I know the significance of the notched hole in the board, but frankly have never seen one or for that matter found a need for one. I have found that most lenses fit just slightly differently on each camera and I would not want to be limited in how I can place the shutter on the board. If it is important that you have a notch, then use a dremel tool and notch the board yourself. If there is a screw on the shutter that is not allowing the shutter to lie flat on the board, then remove it and move on. All of the lenses that I have had the screw removed long ago or never had one.