Jobo ATL-1500 Manual/Editing Programing

As you can tell, I am resetting my ATL-1500 after a move and a while away from analog photography due to health reasons.

I am trying to find the latest manual. I found one online but for the life of me, I don't think it is the latest. Am I crazy but isn't there a way to change the timing of the different steps? In the manual I found it didn't mention that at all.

I know you can't change the operating temperature--why they picked 74 degrees for BW--I will never know. If memory serves, you press two buttons to get into editing mode--to change the amount of time for each step for each program- but the manual I found doesn't have it.

Is my memory faulty or is my manual bad? If anyone has a good link to the 1500, I would be very grateful.

Yes, it's possible to change the step timings via the two buttons immediately above the one used to run the rinse hose on the RHS of the control panel (with processor lid open). Most of the manuals online seem to be for the 1000, not the 1500 - Jobo may still be able to supply the instructions for the 1500.

Thanks Lachlan. I checked there site—nothing. I sent an email to i_info@jobo.com . Hopefully they will respond.

It is on the Jobo USA site for free download:
https://jobo-usa.com/manuals-&-documentation

Specifically:
https://img1.wsimg.com/blobby/go/059fdc02-f8c5-4493-829d-bd516896d654/downloads/AutoLab ATL-1000 _4210 and the AutoLab ATL 150.pdf?ver=1626884388196

Thanks so much! I had the old Jobo USA site.