Jobo ATL-1 Manual

[fabbroni]

Please, is there anyone who has the Jobo ATL-1 instruction manual ? I've bought it used, but I can't find the manual anywhere.
Thanks to all in advance
Fulvio

 

[David_A]

I don't know if if this will help
http://www.jobo.com/jobo_service_analog/us_analog/instructions/instructions_manual_atl-2x00_00.htm
I think they might have been renamed 2200 in these instructions.

David

 

[fabbroni]

Jobo ATL-1

Thank you, David; I looked at the link, but the 2200 is a newer model: the ATL-1 is the CPP-2 with the automatic programming head AT-1, the series 200x is the fully automatic one

 

[2F/2F]

I might have it, but I don't know for sure if it is that model. It will take some digging, then I will let you know.

 

[2F/2F]

Actually, it took no digging whatsoever. It was right on my desk. Unfortunately, it is for an ATL 2.

 

[Lowly]

Just a bump for this thread - looking for a manual for the ATL1. Or some advice on what the two hoses are on the AT1 head - is one the rinse and one the cold water and which is which? And can I plop them from a tempering bath or do they need to be fed under pressure. A picture would be very useful of people's setups.

Thanks for any assistance.
L

 

[frobozz]

I really don't know the differences amongst all the models, but in case my scan of my ATL-3 manual would help you, here it is:

http://www.backglass.org/duncan/darkroom/jobo_atl3/jobo_atl3_manual.pdf

Duncan

 

[Lowly]

Thanks Duncan.

Just got the ATL1 manual in pdf form. Thanks Omer.

Now to get some drums and start developing - woo hoo!

 

[eyushy]

Jobo ATL-1

Hi would it be possible to send me the Jobo ATL-1 PDF. I have a chance to buy one and need to know a little about the machine.

Thanks Marc

 

[fabbroni]

ATL-1 docs

Here is all you need, except for the manual, whose file is larger than the Apug site accepts. If you send to me your email address, I'll send it soon.
Regards
Fulvio

 

[eyushy]

Hi thanks alot!
The manual would be great too, my email is eyushy@hotmail.co.uk

All the best marc Mcelligott

 

[eyushy]

Hi i have also bought a jobo atl-1 and am a little confused about the water tempering.How have you managed to solve this problem? I was thinking somehow to run my mixer tap into the machine.Maybe i could have a run off valve so to set the water temp then cut it off when the temp is correct into the machine?

Regards Marc

 

[eyushy]

water tempering

Hi i have also bought a jobo atl-1 and am a little confused about the water tempering.How have you managed to solve this problem? I was thinking somehow to run my mixer tap into the machine.Maybe i could have a run off valve so to set the water temp then cut it off when the temp is correct into the machine?

Regards Marc