is rainwater comparable to demineralised water?

Hidden

A
Hidden

  • 0
  • 0
  • 18
Is Jabba In?

A
Is Jabba In?

  • 2
  • 0
  • 32
Dog Opposites

A
Dog Opposites

  • 2
  • 3
  • 132
Acrobatics in the Vondelpark

A
Acrobatics in the Vondelpark

  • 6
  • 5
  • 222
Finn Slough Fishing Net

A
Finn Slough Fishing Net

  • 1
  • 0
  • 119

Recent Classifieds

Forum statistics

Threads
197,477
Messages
2,759,653
Members
99,514
Latest member
cukon
Recent bookmarks
0

markbarendt

Member
Joined
May 18, 2008
Messages
9,422
Location
Beaverton, OR
Format
Multi Format
Precipitation naturally condenses around impurities in the air, dust, ash, and other stuff. Downstream of power plants in the eastern USA we famously had/have acid rain. So the answer is that it depends on what it's condensing around and pulling out of the air.
 

quejai

Member
Joined
Jan 28, 2013
Messages
6
Format
Med. Format RF
Demineralised water is more pure than rainwater is more pure than tapwater.

If you live in an urban environment, it's closer to tapwater from absorbing carbon dioxide (turns it to weak carbonic acid) and etc from pollution in the air.
If you live in a rural place, it's much closer to demineralised water.

Either way, wait out the first 10 minutes or so of rain to 'wash out' the air, and then collect water after that. It's the cleanest you're going to get.
 
OP
OP
hoffy

hoffy

Member
Joined
Jan 21, 2009
Messages
3,067
Location
Adelaide, Au
Format
Multi Format
Demineralised water is more pure than rainwater is more pure than tapwater.

If you live in an urban environment, it's closer to tapwater from absorbing carbon dioxide (turns it to weak carbonic acid) and etc from pollution in the air.
If you live in a rural place, it's much closer to demineralised water.

Either way, wait out the first 10 minutes or so of rain to 'wash out' the air, and then collect water after that. It's the cleanest you're going to get.
OK, so my father was kind of right, because we lived on a farm in a rural area, 150KM away from the closest city.

But for me....OK, I suppose I would also then need to consider filtration, which in the end might just end up being just as easy to buy the 4 litre bottles from the super market.
 

Gerald C Koch

Member
Joined
Jul 12, 2010
Messages
8,139
Location
Southern USA
Format
Multi Format
Even if you live in an area with very hard water you can soften it by vigorously boiling tapwater for 5 minutes and allowing it to stand overnight. The temporary hardness (calcium ions) will precipitate out. The permanent hardness (magnessium ios) have no effect on photographic uses. The next day decant or filter off of the clear portion for use in developers.
 

hdeyong

Member
Joined
Mar 5, 2009
Messages
344
Location
France/Canada
Format
35mm
I collect and use rain water, (we live a good distance from any cities), and have had good results. We have a lot of limestone in the water here, so I use the rain for a final rinse and with the wetting solution. I'm pretty sure the film is drying a lot cleaner. But, as a couple of people have noted, I wouldn't even think of it in a big city.
 

Marc B.

Member
Joined
Oct 24, 2010
Messages
357
Location
USA, Pac/NW
Format
Multi Format
Another source for what is basically distilled water is the ice build-up you have to chip away from a freezer.
(De-frosting a non, frost-free freezer, of course). If you're in the city, I'd just buy the distilled bottled water.
I suppose the photography folks living in Bermuda have it easy, (for distilled/demineralized water),
as the Island's entire water supply is captured rain water.

Marc
 

Gerald C Koch

Member
Joined
Jul 12, 2010
Messages
8,139
Location
Southern USA
Format
Multi Format
Not all air pollution is particulates. There are also dissolved gases; sulfur dioxide, various oxides of nitrogen, hydrocarbons, etc.
 

fotch

Member
Joined
Mar 16, 2005
Messages
4,774
Location
SE WI- USA
Format
Multi Format
Even if you live in an area with very hard water you can soften it by vigorously boiling tapwater for 5 minutes and allowing it to stand overnight. The temporary hardness (calcium ions) will precipitate out. The permanent hardness (magnessium ios) have no effect on photographic uses. The next day decant or filter off of the clear portion for use in developers.

I would think the cost of heating, boiling water would exceed the cost of just buying distilled water, unless it just not available where you live.
 

Vaughn

Subscriber
Joined
Dec 13, 2006
Messages
10,012
Location
Humboldt Co.
Format
Large Format
I used rain water to develop negs in Austrailia. The house on the farm was no longer being used (but made a decent darkroom until the lightning storm came by). I had to use milk filters to filter out the various larve, but the negs came out fine. I had to stop while the storm was nearby, as the window coverings were not 100% light tight.
 

Oxleyroad

Subscriber
Joined
Jun 26, 2007
Messages
1,273
Location
Back in Oz, South Oz
Format
Multi Format
Ash,

My darkroom only uses tank water. Came about as a result of our water restrictions we had several years back.

The tank water goes through four filters. A 20µm washable screen filter takes out all the big bits from the tank water and this water is also used for the toilet and washing machine. Then in the darkroom there is an under sink unit with a 1µm wound fibre to get rid of the sediment, a mixed bed resin filter for heavy metals (there is a lot of lead on my roof) and finally 0.5µm carbon block filter. I change the filters in the darkroom every 12 months.

It works for me. But I have never measured the pH nor have I bothered to see what might still be there.
 

Gerald C Koch

Member
Joined
Jul 12, 2010
Messages
8,139
Location
Southern USA
Format
Multi Format
I would think the cost of heating, boiling water would exceed the cost of just buying distilled water, unless it just not available where you live.

It would all depend on how much each person pays for electricity or gas. Distilled/de-ionized water runs $1.00 to $2.00 per gal here in the US. Ads for electric home distilling machines claim to produce a gallon for $0.25. So boiling a gallon of water for 5 min should certainly cost far less than this. From a similar thread not so long ago some people in Europe pay exorbitant prices for distilled water if it is availale at all. .
 
Last edited by a moderator:
OP
OP
hoffy

hoffy

Member
Joined
Jan 21, 2009
Messages
3,067
Location
Adelaide, Au
Format
Multi Format
Ash,

My darkroom only uses tank water. Came about as a result of our water restrictions we had several years back.

The tank water goes through four filters. A 20µm washable screen filter takes out all the big bits from the tank water and this water is also used for the toilet and washing machine. Then in the darkroom there is an under sink unit with a 1µm wound fibre to get rid of the sediment, a mixed bed resin filter for heavy metals (there is a lot of lead on my roof) and finally 0.5µm carbon block filter. I change the filters in the darkroom every 12 months.

It works for me. But I have never measured the pH nor have I bothered to see what might still be there.

Thanks Andy,

For general all purpose chemical dilution and mixing, I use filtered tap water, except for doing colour. I have always used Demin water for the final rinse when developing film. I have found that this is the best way to ensure clean streak free negs. I had thought of using demin for the whole process, but the price of buying 4 litres at a time has put me off.

I believe Polyglot uses bottled spring water (for the chems at least), but I believe his tap water is really quite bad.
 

RattyMouse

Member
Joined
Oct 18, 2011
Messages
6,046
Location
Ann Arbor, Mi
Format
Multi Format
Even if you live in an area with very hard water you can soften it by vigorously boiling tapwater for 5 minutes and allowing it to stand overnight. The temporary hardness (calcium ions) will precipitate out. The permanent hardness (magnessium ios) have no effect on photographic uses. The next day decant or filter off of the clear portion for use in developers.


Incorrect. Boiling the water increases the hardness up until you reach the saturation point, and then salts will begin to precipitate out. You will be left with severely hard water.

Magnesium and calcium ions act have almost the same reactivity.
 

Gerald C Koch

Member
Joined
Jul 12, 2010
Messages
8,139
Location
Southern USA
Format
Multi Format
Incorrect. Boiling the water increases the hardness up until you reach the saturation point, and then salts will begin to precipitate out. You will be left with severely hard water.

Magnesium and calcium ions act have almost the same reactivity.

??? NO on all counts.

The temporary hardness in ground water comes from the presence of soluble calcium bicarbonate. When the water is boiled briefly this compound decomposes to form calcium carbonate which is insoluble. All cacium salts are effectively removed from the water. Calcium in water used in photographic solutions can causes problems with high sulfite containing developers like D-76 where it precipitates out as calcium sulfite and in carbinate containing developers like D-72.

Magnesium compounds are soluble and only affect water when soaps are used for washing. Both calcium and magnesium form insoluble soaps which stick to cloth fibers. Magesium salts in water are not a concern in photography.
 

Noble

Member
Joined
Nov 25, 2012
Messages
277
Format
Multi Format
I only drink distilled water, or rainwater, and only pure grain alcohol.

While minerals in water may have an adverse effect on the film development process your body needs them. A little calcium is good for your bones. Try spring water.

From a similar thread not so long ago some people in Europe pay exorbitant prices for distilled water if it is availale at all. .

Why is this? In some European countries it's a pain in the @$$ to get distilled water and in the US it is sold all over the place by the gallon (milk and petrol are sold by the gallon as well). I use distilled water at various points in the processing workflow. What is everyone else using it for?!
 

Oxleyroad

Subscriber
Joined
Jun 26, 2007
Messages
1,273
Location
Back in Oz, South Oz
Format
Multi Format
Ash,

I understand you are/might be coming to Melbourne early March. You have to look me up if you have the time and I can show you the set up and the darkroom.
 

RattyMouse

Member
Joined
Oct 18, 2011
Messages
6,046
Location
Ann Arbor, Mi
Format
Multi Format
??? NO on all counts.

The temporary hardness in ground water comes from the presence of soluble calcium bicarbonate. When the water is boiled briefly this compound decomposes to form calcium carbonate which is insoluble. All cacium salts are effectively removed from the water. Calcium in water used in photographic solutions can causes problems with high sulfite containing developers like D-76 where it precipitates out as calcium sulfite and in carbinate containing developers like D-72.

Magnesium compounds are soluble and only affect water when soaps are used for washing. Both calcium and magnesium form insoluble soaps which stick to cloth fibers. Magesium salts in water are not a concern in photography.

Thank you for informing me of this.
 

Oxleyroad

Subscriber
Joined
Jun 26, 2007
Messages
1,273
Location
Back in Oz, South Oz
Format
Multi Format
Its the easter weekend - Not sure if I have time, as I am travelling with someone else, but if I do, I'll be in contact!

Bother, the Easter w/e is when the family and I are out of town - up in Mildura. Next time hey.
 
Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links.
To read our full affiliate disclosure statement please click Here.

PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:



Ilford ADOX Freestyle Photographic Stearman Press Weldon Color Lab Blue Moon Camera & Machine
Top Bottom