How To: Remove the film door from Canon EF?

Hi guys,

This is probably a simple answer, but I'm just scratching my head trying to figure it out.

I'm trying to replace the light seals on my EF, and to do so I need to remove the film door. I have removed the tiny screw pin on the door but I can't seem to figure out how to actually get the door off.

Anyone know how to accomplish this?

Thanks!

Lift the leather at the hinge end of the camera body where it meets the hinge. There should be 3-4 screws under it. I believe the hinge is riveted to the door itself.
A little isopropyl alcohol at the edge and gentle pushing/lifting of the leather is all that's needed.
Pliobond or contact cement works to refix it.. If contact cement, apply it to one surface only

When I resealed my EF I had the same problem. When you unscrew that small screw the hinge should slide downward and the door should then come off. I couldn't get the hinge to budge even with WD-40. I didn't want to do damage so what I finally did was just scrape off as much of the old seal near the door as I can and cut the seal just a tiny bit less than if the door was taken off. I haven't had any problems with light leaks.

I did Finally finally get the door off! I put a tiny drop of Wd-40 in there and used a screw driver to push down the top part of the pin. It finally popped open and I was able to get the door off the hinge. Thanks to all who offered tips!