I've had some past experience some years back with LF but just with various Graflex rigs and moderate quality optics (Ektars, Xenars). I've got an old Yankee daylight tank someplace and a 150mm Rodagon for printing. I'm assuming this is decent enough for printing, at least to start with? Any film holders to avoid? I've got a Rodenstock 4X loupe, is this adequate for ground glass duty?
Just what I was thinkin'.A 203 Ektar and a 135 WF Ektar are moderate quality?
Just don't go around trash talkin' those Ektars!
As was I - but about the Xenars.
Since this thread has a lot about Fujinon LF lens. I have one I can not find any information on it.
300mm S f5.6 in a Copal 3 and it has a 82mm filter.
Anyone know anything about it?
Thanks
Mike
A 203 Ektar and a 135 WF Ektar are moderate quality?
Craig, Craig...tsk...tsk!>SNIP
SNIP<
Just don't go around trash talkin' those Ektars!
Thanks Gary
I thought I was the only person on the planet to own one of these!
I had posted here and over on the LF forum several times and had not got a single response.
I'm plenty happy with the lens, I just have NEVER seen any information on it. I'd buy a 210mm S if one came up, I like the 300mm so well.
What size filters does your 210 take?
Thanks again
Mike
Gary
Do you know if this is a 3 or 3S copal, I'm not use I know what the difference is.
Thanks
Mike
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?