Hasselblad 205tcc no aperture information in display

hello,

i own 205tcc for about 10 years in very good condition.
i shoot with the camera very rarely and in the beginning everything worked just fine.
at some point, about 3 years ago the display stopped showing the aperture number, instead two dashes (- -).
i have two original 205tcc lenses (80mm and 50mm), i get the same behaviour with bot lenses. the lenses are also in mint condition.
the camera was already twice in independent repair shops but was returned back with the advice to send it to the factory in sweden.
no one was sure what exactly the problem. some say it is the controller of the metering or the flex cable between the lens contact and the controller.
im not sure if both technicians were very good hasselblad specialists.


all other functions of the metering and all different programs are shown correctly in the display.


i would be grateful for any advices.

Are your contacts clean?

cowanw said:

Are your contacts clean?

Click to expand...

thanks for the reply!
yes, i already cleaned them when the problem appeared.

It is possible that you will need a replacement display circuit board, I have seen this problem many times and sadly there are no shortcuts or workarounds.

Douglas Fairbank said:

It is possible that you will need a replacement display circuit board, I have seen this problem many times and sadly there are no shortcuts or workarounds.

Click to expand...

do you know if it's possible to order the cirquit board as spare part?

thanks!

I am sure that you could order it if it is still available but there is no way that this could be replaced by an inexperienced person. I think you need to contact Hasselblad.