Recovering Silver from used fixer
Rather than dumping used fixer down the drain and into either the local sewer system, or to your septic tank, I pour it into a large 'carboy. Adding 'used'- but not dead 'print' or 'film' developer... agitate (and I don't mean being mean or 'shouting' at it) leave it to 'stand" for a while, Carefully decant... or syphon off as much of the liquid as possible.. maybe a further was 'wash' (or two) with clean water let it settle again, The precipitate at the bottom of the container is what is known as "Black silver" probably the 'purest of silver you will find....
Have it melted down in a muffle furnace.... after it cools down.... to a 'lump of pure silver, you could probably sell quite readily it at your 'favourite' jewellery repair shop.
Ken
[Who will gladly accept a small $$ percentage...
]