Hi everyone hope all of you are safe and sound and getting some time in the darkroom! I recently have fired up my Fujimoto Cp-32 processor for RA-4 and have lost the manual over the years. I have exhaustingly searched the internet and have only been able to come across some old deleted cp-32 threads or comments saying the Cp- 31 is basically the same as the 32 which is actually not totally accurate - the 32 drawer is a circuit board only and has a completely digital control panel (without the pullout drawer to access the knob for transport speed like the cp31). I have been fumbling through the mode and set buttons for temperatures but am struggling to get the transport speed set. If there are any cp 32 owners who have some advice or could point me in any directions that would be AMAZING!!! Again Thanks for any support and or advice!! Be well and stay healthy!!