For Sale FS: Packard Shutter and Bulb $29 - for repair

[Jon Shiu]

SOLD

Packard Shutter with 2 3/4" or 69mm hole. Overall width is about 5 1/8".

The shutter works, but because the bottom of the case has been cut off (C), the blades can get jammed. If one were to put a stop, strip of wood, on the lens board to keep the blades from moving down too far, it would work fine. See pictures, where at point (A,) it can get too low and locked up against the screw post.

Additionally, I glued some cracks in the blades and a piece of aluminum where the notch (B) part broke off. The instant, "pin" mode doesn't work.

Includes bulb and tube. I don't have any use for this, but hope someone can make use of it.

$29 plus postage. Paypal accepted.

 

🛡️ Classifieds Safety Reminder: Please stay safe when buying and selling. Scams via hacked accounts are on the rise globally.

Best Practices: Always use a verified payment method with buyer protection (avoid "PayPal Friends & Family"). Services like Escrow.com are highly secure. Be suspicious of random unsolicited contact via Private Message. If you see suspicious behavior, please use the Report link on the post immediately.