Hi there,
I recently acquired a durst rcp 20 for tabletop RA4s 8x10 color prints. The machine looks pretty straight forward and I started the conversion process to speed up the timing belt - the only thing that's really confusing me is the replenishing rates. The machine takes 2L of developer and 2L Blix/bleach, leaving me with 3L of each solution - the directions don't mention anything about a starter or replenishing other than, after your 2nd session, dump 1/3 of the chemistry and refill for replenishment.
Does anyone have any advice and if I should be adding chemistry every 5-10 pages, or something of that sort? Looking to get the most consistent results day to day.
In the future, ill likely print 1-2 times a week, but this is my first go and will probably go for Kodak chemistry next.
Any advice appreciated. Thanks!
I recently acquired a durst rcp 20 for tabletop RA4s 8x10 color prints. The machine looks pretty straight forward and I started the conversion process to speed up the timing belt - the only thing that's really confusing me is the replenishing rates. The machine takes 2L of developer and 2L Blix/bleach, leaving me with 3L of each solution - the directions don't mention anything about a starter or replenishing other than, after your 2nd session, dump 1/3 of the chemistry and refill for replenishment.
Does anyone have any advice and if I should be adding chemistry every 5-10 pages, or something of that sort? Looking to get the most consistent results day to day.
In the future, ill likely print 1-2 times a week, but this is my first go and will probably go for Kodak chemistry next.
Any advice appreciated. Thanks!