I'd like to recover my Olympus OM2n using fabric from an old pair of jeans instead of the usual leather/snakeskin etc...
I was just wonder what the best way of going about it would be. Is there a way of preventing the sides of the denim from fraying?
My original thoughts on this was to cut the denim to size and use Copydex on the back in a bid to prevent fraying and as an adhesive to stick it to the body. What do people think?
At fabric stores, you can get stuff that can be attached to denim to make it waterproof behind it, at least. It will also stiffen it so it's sturdier. There's also likely something you can put over it to seal it somewhat. It's not going to be a great cover for this camera, though. I'd do it on a Holga.
Some kind of contact cement will hold it to the body, get the solvent based stuff as it tends to work better. There are several products that are designed to stop denim from fraying, if you coat a larger piece than you need, it should help prevent fraying after you cut it. The cement will also help prevent fraying.
If you try to double over denim, it may be too thick. Try some "Fray check" at the sewing store...it's like putting a glue at the edge of the material so it won't fray. Of course, I rather like the idea of denim fraying...looks very retro-hippie!
Based on the replies so far, I think I'll first treat the fabric with a waterproofing solution. Let that dry, then cover one side with my contact cement, cut to size and stick it on.
If you think laminated canvas mounted prints, you could apply the laminating material in a dry mounting press to the denim then use this to cover the camera
Personally I wouldn't worry too much about being waterproof, the contact cement will give you a barrier between the camera and the cloth. And any waterproofing will make the cloth harder. Even the fray stop stuff will cause it to be a little less soft.
If you go to the fabric shop you should find iron-on patches for denim. They are already water-proof and sized, completely flat, easy to cut and should not fray.
You can purchase the IRON on adhesive in rolls at Wallmart or other fabric stores, and it doesn't cost an arm or leg. Just cut out a over sized piece and use an iron to transfer it to your choice of fabric. You can even use a dry mount tacking iron to activate the adhesive.
If you don't want to double over the denim, you can look for something called selvedge denim, denim that has it's own cotton edge to it so it doesn't fray. The only problem is that it can be hard to find.