- Joined
- Jan 30, 2006
- Messages
- 351
- Format
- Large Format
Has anyone ever successfully cut down a square bellows and joined them together again as a tapered bellows?
I have some nice square bellows for a project camera but I really need them to be tapered. I thought I could slice them down the middle of the flat side and re-tape it together.
The only problem might be that the corners would not cooperate since the folds would be at different angles. If the taper was not severe this might not be a problem.
I have some nice square bellows for a project camera but I really need them to be tapered. I thought I could slice them down the middle of the flat side and re-tape it together.
The only problem might be that the corners would not cooperate since the folds would be at different angles. If the taper was not severe this might not be a problem.
