Canon EOS 600 range.

[roy]

I have a malfunctioning EOS 650 and an EOS 600 needing new seals on the back cover. The obvious answer would be to swap the backs over and I was wondering if any member had experience of removing the back from a camera in this range and whether there were any particular problems.

 

[Ryuji]

Do you mean that foam gasket deteriorated? That is replaceable.

Also, just FYI:

More of a problem with 600 series is gummy shutter blades. When you pick up an old piece that was resting for a while, you may not see the problem immediately but you will soon see it after a few rolls of shooting. This is due to deteriorating rubber bumper in the shutter assembly.

Battery draining problem is also very common with 600 series. This is due to leakage current of the backlight power supply unit. I've disconnect this unit as it is not essential.

 

[mcgrattan]

"More of a problem with 600 series is gummy shutter blades. When you pick up an old piece that was resting for a while, you may not see the problem immediately but you will soon see it after a few rolls of shooting. This is due to deteriorating rubber bumper in the shutter assembly"

Yes, my EOS 650 seems to have this problem. I (very) gently cleaned the gummy stuff off the shutter blades and, fingers crossed, it's been fine -- I ran a few hundred shots off with no film in the camera without it sticking and have done this every couple of days for a week or two, and the sticking hasn't recurred so far.