Cable for Ilford Multigrade 500CPM Controller?

[GM Bennett]

Help!

I've been happily using my Ilford Multigrade 400 system, but recently found one of those "can't refuse" deals on a 500H head, 500S power supply, and 500CPM controller. The 500CPM controller is new in the box, the vendor tells me that the old controller (probably an older 500C based on my subsequent research) broke down, was repaired, and the new controller stayed in the box.

The rub is that the new controller takes an 8-prong male-to-male cable to connect to the 500S power supply, whereas the older controller had a hard-wired cable. I don't have the old controller, unfortunately, so I need a new cable. It's probably too much to hope that anyone here has one for sale, but if anyone has a wiring diagram (I assume that the wires go pin to pin, but don't know if that's actually the case) I'd be extremely grateful.

Thanks in advance, Graham

 

[mitch brown]

cpm cord

hi you can purchase it from khbphoto on ebay where i got mine.
mitch

 

[mitch brown]

sorry i ment the wiring diagram
mitch

 

[GM Bennett]

Thanks

sorry i ment the wiring diagram
mitch

Thanks, Mitch. I contacted them yesterday; I'm going to bring the whole system in when I'm next driving by Mississauga. Graham

 

[Bob F.]

You can get some manuals for Ilford MG heads from Ilford/Harman here: (http://www.ilfordphoto.com/products/page.asp?n=161) but I've no idea if they have the one you need.

Good luck, Bob.

 

[GM Bennett]

Thanks, Bob

You can get some manuals for Ilford MG heads from Ilford/Harman here: (http://www.ilfordphoto.com/products/page.asp?n=161) but I've no idea if they have the one you need.

Good luck, Bob.

Thanks, Bob - the schematic of the power supply in the service manual was what I was looking for. Regards, Graham