Broken Gravity Works 4x5 Film washer

Hi all,
I have a Gravity Works 4x5 film washer that I, unfortunately, broke.
The clear pipe that empties the washer when the water reaches a certain hight has broken at the point where it attaches to the washer.

I have searched plumbing supply houses and the usual box home repair stores without any luck.

For those who are not familiar with the washer the part I am referring to is a clear pipe that is shaped in an upside down U shape with one side longer than the other. The shorter side is inserted into a pre-drilled hole and the other side of the pipe directs the water into a sink or other draining device.

To compound the problem I only need a section that is approx. 2 feet long. I will trim to the correct length once it is attached.

I would appreciate some ideas on locating such a part.

As far as online ordering, I do not use a credit card and I do not have, and will not open a paypal account. I prefer to pay in cash.

Thanks for the help.

Gary

Money Order and

Gravity Works, LLC
3610 Lexington Ave.
Madison, WI 53714

By phone:
608-241-7673 (between 8 a.m. and 5 p.m. CT)
fax 608-241-7573
gravityworks@sbcglobal.net


Bill Barber

Call them, per Bill's info. They have always been most helpful on the phone and will figure out what to do.

Gary,

If you still have all the bits and pieces a solvent can be used to 'weld' the plastic back together. I bought a used Gravity Works film washer and while in transit the bottom tube broke off cleanly and the top upside down U broke on one side. I used a solvent that was made for plexiglass and it worked perfectly.

Scott