Behavior of Nikon FE's Meter Needle with Non-AI Lenses

FilmOnly

Member
Joined
Jul 3, 2008
Messages
550
Location
Southeastern
Format
35mm
What is the correct or default behavior for the FE's meter needle when using non-AI lenses? With a non-AI attached, one of my FEs behaves differently than the other. This FE's needle shoots right to the top of the shutter speed panel (above the "A" setting), and then will go up and down if I point it at either brighter light or darker areas. The other FE's needle does not shoot right to the top of the panel, but does go up and down as per the lighting. Are there any problems or issues here? I am thinking that both FEs should act in the same manner. Please correct me if I am wrong. I realize, of couse, that it will meter with these lenses only when stopped down.
 

BobD

Member
Joined
Dec 22, 2006
Messages
1,113
Location
California,
Format
Analog
When using the FE with pre-AI lenses you flip up the meter coupling lever
on the camera's lens mount before mounting the lens. Then the lens can
be used via stop down metering (press stop down lever and take reading).
 

LudditeJay

Member
Joined
Aug 3, 2010
Messages
54
Format
Multi Format
When you say, "This FE's needle shoots right to the top of the shutter speed panel (above the "A" setting), and then will go up and down if I point it at either brighter light or darker areas.", do you mean that the readings are completely off but that it at least reacts to changes in light?
 
OP
OP

FilmOnly

Member
Joined
Jul 3, 2008
Messages
550
Location
Southeastern
Format
35mm
My comments have been misunderstood. I am aware of the meter coupling lever. I am not trying to meter. I am just observing the differences between the behavior of the two cameras with a non-AI lens properly mounted (i.e. with the lever flipped upward). Again, when the lens attached, the meter needle shoots straight upward. On the other camera, it does not do this. This puzzles me a bit. Both camera's needles make some type of reaction to light (but, again, this is while simply looking through the viewfinder, and not stopping down via the DOF preview lever).
 

BobD

Member
Joined
Dec 22, 2006
Messages
1,113
Location
California,
Format
Analog
I wouldn't worry about it then. Nikon made many internal changes within model runs (in those days
at least) and you may simply be seeing evidence of such.
 

LudditeJay

Member
Joined
Aug 3, 2010
Messages
54
Format
Multi Format
I would echo Bob's comment. I have never owned an FE but did own an FE2 for several months and it behaved in much the same fashion. I never had a problem with the meter, so if they are both metering correctly let them be.
 

dehk

Member
Joined
Aug 4, 2010
Messages
881
Location
W Michigan
Format
Multi Format
Just to throw this out there, i just mounted my Nikkor Q 200mm f4 NAI on the FE just to see. The needle stayed "normal", it did not shoot up and down (did not go all the way pass A, stayed around at 1/250ish) on a sunny 16 day ISO 100. It was metering perfectly as if i would have to shoot in f4.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…