I recently got a 70mm film loader with some film still in it. The base of the film on the exposed leader is a dark teal. I can't recall seeing anything like this before. Anyone have a guess as to what type of emulsion it is? I'm guessing a Kodak B&W aerial film, but which one?
You will probably be okay regardless of the time (within reason). Since you are just looking for edge markings, I would start with something a tad on the long side and if they block up, which I find hard to imagine, then you can cut back. I have never developed film long enough to block up the rebate, so I think you are good.
Why don't you cut off a short strip, develop it, and check the edge markings, if any. Most major manufacturers identify film by small print on the edge of the film, with at least on mark per foot. Any reasonable black and white developer for any reasonable time should be good enough to develop this information.
Guess that thread's a few years old, Steve..! But they do come up on ebay from time to time for about $100, which isn't bad, considering you can occasionally find the film for almost nothing.
I've only seen one on eBay lately. I was floored at what it sold for!
I had no idea! I remember seeing them in old photography catalogs in years past. If I'd only known then what I know now.
I've searched for 70mm film and noticed that about all you can find is non-perforated. If my memory is correct, those loaders had spockets that engaged the perforations on the film, like the 35mm loaders do.
WHERE can you find perforated 70mm film?
I truly wish that someone other than Kodak made 70mm film.
Agfa-Gaevert still makes 70mm perfed aerial film which is occasionally available, but a bit pricy. It has a slight extended-red sensitivity. A little less than Ilford SFX. Fotoimpex might be able to track it down. When J&C ordered it, the minimum order was less than Kodak's.