I tested my C-41 chemical with an unknown roll of film from a camera I purchased a while ago. I did not shoot the film, so I do not know much about it. It is a Kodak max.
The film looks over-exposed. It looks too green. The CN-41 chemicals are old (open bottle concentrate) and I was thinking of dumping the open bottles and restart from sealed bottles. I do not know if the chemicals are bad, or just the over-exposed negative.
The film was scanned with Minolta Elite 5400 film scanner.
There is very definitely a colour shift somewhere along the line. It may be the film is old and where it was kept in the camera was not the best environment. Before dumping the chemicals it may be worth doing a short test film to check if the results are the same.
To test the chemicals you only need to use six inches of film. Shoot a few exposures on fresh film and cut the exposed footage directly from the camera, in a darkroom or changing-bag.
To test the chemicals you only need to use six inches of film. Shoot a few exposures on fresh film and cut the exposed footage directly from the camera, in a darkroom or changing-bag.
The best test is to shoot a MacBeth target, or the color target found bound into an old color Darkroom Dataguide. I shoot whole rolls at a time, and then clip a few inches onto the eld of a reel with each fresh mix of c-41 to spot bad chems or mixing errors.