michael9793
Allowing Ads
Since my supply of Micro-X is getting very limited. I thought I would try some other developers that are on the market. One that caught my eye was Acufine. It says Ultra-fine grain and maximum acutance. So I tried it just as they say on the label. very gentle agitation and half as much.Will, the first couple batches were outstanding. I scanned the negative and blew it way up to check the grain and it was very good. My tones came out perfect for me. I use Tri-x and bumped it up to 1600 asa as you can see from my 6x17 images on the gallery they came out good. One of the reasons I shot at 1600 is with Florida water, the coldest it gets in the summer is 74-75 degrees. If I did 400 asa my developing times would be 2-4 mins and I just feel that is too short a time on any film. I would love to try some 100 asa films and see where that gets me. APX 100 at 200 asa is 5.5 mins and that may be usable.
NOW I STARTED HAVING GRAIN PROBLEMS ON A COUPLE OF ROLLS A WHILE BACK. What I found out was I has giving it my normal agitation and the grain just jumps out. So I went back to my almost not agitating sequence and the grain again become very fine. So If you want to use this film agitation is a bad word and just moving it enough to get new developer on the film is all you need to do. I hope this helps someone out there I just thought i would share this info with you.
NOW I STARTED HAVING GRAIN PROBLEMS ON A COUPLE OF ROLLS A WHILE BACK. What I found out was I has giving it my normal agitation and the grain just jumps out. So I went back to my almost not agitating sequence and the grain again become very fine. So If you want to use this film agitation is a bad word and just moving it enough to get new developer on the film is all you need to do. I hope this helps someone out there I just thought i would share this info with you.
