How can I mask off my 6X9 carrier to 6X7? Is this practical/possible as a temporary measure? I am trying to find a 6X7 carrier for my Beseler 23C2.
Thanks,
Gerry
Take a sheet of paper and leave it in the room lights and develop, fix, and wash it in a lighted room, as you want it black.
Layout the width of the film with pencil and ruler and layout the window opening you want. Cut out the window with a single-edged safety razor. Its easier to cut the width with scissors.
Simply lay the mask on top of the negative on the carrer, close the carrier and put it in the enlarger in the usual manner.
If the locating pins of the carrier make this difficult you can place the mask on top of the top plate and secure it with two small pieces of easily removable (low tack) drafting tape.
I cut a piece of rubylith to hold 6x6 in my 6x7 carrier. I know this isn't much difference compared to 6x9 with 6x7 but it seems to work, especially since there is generally enough extra film that it is fully supported by the carrier in my case.
I cut a piece of rubylith to hold 6x6 in my 6x7 carrier. I know this isn't much difference compared to 6x9 with 6x7 but it seems to work, especially since there is generally enough extra film that it is fully supported by the carrier in my case.
I like to see the whole frame so I just use a 6x9 carrier for 6x7 and no masking. Seems to work for me. I do the same with 645 in a 6x6 carrier. Try a test with masking and no mask and see what you think.
Like ChuckP indicated. Just use the 6x9 carrier. I'll bet that people that crop 6x9cm negatives to 8x10 or 11x14 paper format when printing don't mask the negative down to 6x7 in the carrier
Agreed, unless you're trying to print the negatives on the end of your strip, just crop with your easel. I personally like to have a lot of light leak around my negative onto the paper, it centers the image better i feel, and gives the whole thing a bit more interest. that may or may not be what you like to do, but either way, you can still crop out all the light leak with your easel. This is most successfully done with a 4-blader