65mm horseman recessed board 3d print..

Ibicus · May 22, 2024

Good morning,
I was looking for a recessed board for my 65mm f7 super topcor for my VH, but as I can't find one, I considered to get a 3d printed one, or build it myself. Do anyone knows somobody who prints and sells them, or alternatively someone who has done it can tell me the exact measurements to build the design? For example, I'm not sure how wide the central hole should be, and how far the plate should recede.

Thanks,
Marco

Dan Daniel · May 22, 2024

Not sure if he handles that specific camera and board. but I've dealt with this guy outside of Toronto for good results. Not only was his 3-d printing very good, he knows cameras and understood my concerns on a custom part and made it work the first time.

Miroslav Francruz https://customcamerabuilding.com/en-us

Dan Fromm · May 22, 2024

Ibicus said:
Good morning,
I was looking for a recessed board for my 65mm f7 super topcor for my VH, but as I can't find one, I considered to get a 3d printed one, or build it myself. Do anyone knows somobody who prints and sells them, or alternatively someone who has done it can tell me the exact measurements to build the design? For example, I'm not sure how wide the central hole should be, and how far the plate should recede.

Thanks,
Marco

Why? They were sold on a flat board, so shouldn't need a recessed board. What have I missed?

xkaes · May 22, 2024

I recently sold a flat, metal board on EBAY. There were plenty of others listed then -- and I assume still are now.

ic-racer · May 22, 2024

I have come across three versions.

1) Early version with hammered metal finish. Flat lensboard
2) Later version that accepts interchangeable solenoid with recessed lensboard.
3) ER-1 version with built-in solenoid. Also recessed.

My experience is the shutters are actually different in that the lens elements of the early one won't fit the shutter of shutters mounted on the recessed boards.

ic-racer · May 22, 2024

The 75mm was the same way (came in two different shutter/lensboard configurations). The lens elements are not interchangeable between the two.

Ibicus · May 22, 2024

Dan Fromm said:
Why? They were sold on a flat board, so shouldn't need a recessed board. What have I missed?

Because with flat board and 65mm movements will be limited, as the lens is inside the camera.
Later booards are recessed to solve this problem

Ibicus · May 22, 2024

ic-racer said:
I have come across three versions.

1) Early version with hammered metal finish. Flat lensboard
2) Later version that accepts interchangeable solenoid with recessed lensboard.
3) ER-1 version with built-in solenoid. Also recessed.

My experience is the shutters are actually different in that the lens elements of the early one won't fit the shutter of shutters mounted on the recessed boards.

View attachment 370853

Hi. Is not possible to dismount completely the lens and the shutter and mount on a new (recessed) board?

ic-racer · May 22, 2024

Yes I think swapping shutters would work but did not try.

In my case, since the lens cells wouldn’t screw in to the shutter on the recessed board, I took all the glass elements to swap those (foggy for clear)

However, once I had all the glass elements removed, they cleaned up just fine, so no swapping needed.

65mm horseman recessed board 3d print..

Privacy & Transparency

Privacy & Transparency