Recent content by Unciauncia

Either my screen was faulty or the ESP32 was - opened up the box to check the usb cable the screen died and the ESP refuses any commands from the buttons. The arduino IDE terminal showed it spasming through modes without me touching anything and now it just to testing and doesn't respond to...

Yes, esp 32, latest available firmware. Alignment in B seems to be okay. It almost feels like the ESP is slow. Should the whole screen refresh instantly or wave like? And it refreshes on curtain open.

I seem to be having problems registering exposure constistently. The tester says ready, I press the release. The "ready" goes away, and no results are registered. Sometimes they get through, but mostly it just refreshes with the same last result. Is it an alignment issue?

I might try sending one. I have plenty, but sending them from where I am is not easy. I'll see if posting one from Moldova is not too expensive. I'll print the jig and try it with a zorki shutter. There are minor differences - some drums have one hole, some feds have a long hole. The feds...

The jig for zenits sounds very nice. Seeing as they're so similar to zorkis and feds could it help with those too? I cut a zorki shutter box to try that but haven't actually used it yet.

Hello! I assembled the tester and need the pass key. Can you please provide one? Can't message because I'm new.