Recent content by Tomsmac

Can you please help me find the “Post new discussion” button? I’d as the group as a whole but I can’t find the “Post new discussion”. Thank you.

Can you please help me find the “Post new discussion” button? I’d as the group as a whole but I can’t find the “Post new discussion”. Thank you.

It works perfectly. Not even a hiccup. The one I posted is the same seller that I got mine. Shipping was faster than almost every U.S. seller that I’ve bought from and if you did run into any issue he’s got a very liberal return policy including return shipping.

Nothing, it’s great. But you should look at the point that I was answering. (In my post)

Why in the world would you purchase the BetterScanning solution when you can invest half of that by buying a wet mount? The BS is basically a weak ripoff of wet mounting.

I’m sure that the profit margin is well above 50%.

I think that I’m going to ask for these (120mm and 35mm) for Father’s Day. When I see something that I want to print I’ll wet mount it. Sounds like a good workflow! Thanks!

That’s why I use Wet Mount Scanning.

“becasue the V850 has those extra layers of glass in the film holders to keep the film flat.” Absolutely maddening.

Got it. Between the rails but on top of the bevels. Thank you.

Here you go… (Sorry, it was 899) https://www.ebay.com/itm/397045522774 I had it in literally 5 days.

Got it thank you. The end result is that after flipping over and putting the carrier onto the scanner bed the shiny side is face down. Thanks again.

Can I double check something with you? When you load your negative into the tray it’s shiny side up, then it gets flipped and placed into the scanner where the shiny side is down, right?

OMGOODNESS yes!

Good morning. The V850 directions state to place the film Strip into the negative tray emulsion side (dull side) up when loading into the tray but the tray needs to be turned over when being placed into the scanner leaving the emulsion side down. And the emulsion side should be up! Can anyone...