Recent content by ronron

Hi, Here is my little analog processor project with an ESP32 and two temperature sensors. i can modify the time by using differents choices tables, formula, Gamma or fix temperature and use the preconization or each manufacturer English version here ...

Hi Niglyn, I found the good esp,

how did you print your parts to get this nice effect?

Nice box ! For the encoder i use the one i have under my hand, the SW is connect to vcc as i can see on the back, i didn't have any problem to start your code with this encoder, for the esp 32, there is no big difference. i usually sold with chip on the card to have the good spacing. Can you...

Hi Niglyn, I've got busy for a while, as you can see i almost finished my V2 with your fantastic board that you send me. I had to change my esp32 board to use an usb c connection, i will need a new code to finish this project, thanks again.

j'utilise 5 lasers avec un interrupteur horizontal et vertical :

hi, i did a little try 1/125 1/500 1/1000,2000,4000 ! before i close all boxes :

oui le capteur et en effet le problème vient de la !

with the 10k it's ok it 's changing on the screen, something goes wrong between laser and esp

Thanks Niglyn there is no change, the only things i see, it is that i have always 3.15v even when there is nothing connected, if i put the laser on, i get 3.10v and 3.15v when i cut the signal between led and laser

I can't get any signal on 25 33 and 32 weird!

i also use a tree position switch to get vertical or horizontal with schottky diode on each receiver, i'm going to try it tomorrow

i did this, you need a hair dryer to plug each laser ball

hi Niglyn, i've just finish it today, can you send me the code? thanks