Recent content by reelquickfilmlab

Yes I discovered I had initially made an incorrect unit conversion when mixing the chemicals for a 5 liter bottle. Ex mixing part A (a 1.5 liter bottle) and dividing it by 4. I used decimal points and when calculating not whole numbers. ( Silly mistake). So I think that solves my problem. I am...

So you add starter to the replenisher separately before you mix a working solution? I thought you only needed starter when making a working solution for the first time with the replenisher.

I see, I think the part in red is what confused me. I thought you were stating that the below was the mixture for the replenisher only.

Pardon my confusion but the part A of the dev replenisher bottle for the 20L kit has a net content of 1.5 liters. If this is the same kit and part A for 1 liter is 64ml wouldn't 64ml x 20 give you 1,280. Shouldn't it equal 1.5 if it's the same ratio? I just want to be absolutely correct before...

The both mixing instructions.

Here is the starter I am using. Someone from another forum had posted the mixing instructions for the flexicolor color replenisher. (3667805). I mixed it into 5L ratios by dividing by 4. I have tried both mixtures for the starter but both have produced thin negatives.

I think it may be the first mixture with the starter since the bottom negatives are four batches in a previous mix of flexicolor. I had the same issue with the negatives coming out thin in that first batch but after a few batches the negatives are more developed. I am using the recommended...

That's what I was thinking but multiple rolls in the same batch are also like this. Also when looking at the borders they are also thin. Can that be due to underexposure?

I have been developing at 102F in a jobo cpe 2. I did try a batch at 105F but results were the same. Top negatives are the recent batch and the bottom is a previous batch before I mixed these.

So I just checked the instructions and I mixed the starter with the replenisher to make a working tank solution correctly. 860ml repleshier -> 18ml starter LORR -> 122ml water. Should I share my negatives? I seem to have done the mixing ratios correctly but still have thin negatives.

Nevermind this. I figured out the ratio but my negatives have been coming out thin after developement and initally thought it was the mixing ratio.

Hello, I foolishly threw away my developer replenisher box, and am having difficultly finding the mixing instructions online for the 20L kit. Does anyone have this information? and if possible in 5L increments? Thanks

Thank you for the information! The Kodak PDF can be a bit confusing.

That's good to know before spending a lot on these chemicals!

So If I am processing in a jobo lift cpe, I will need the starter mixed with the replenisher each time as a one shot developer?