Zabriskie Point #4 - Adox MCC 111

4x5 silver contact print

I probably would have tweaked this a tad more but ran out of paper... Quite happy with it as is. This one seemed to scan a little better than the last two. That's it until the paper becomes available. If anyone else has experience with this new paper make sure to share it in the following thread.
http://www.apug.org/forums/forum172/40721-resurrection-mcc-progressing.html

www.shawndougherty.com
Location
Death Valley, CA USA
Equipment Used
Calumet, 12" Radar
Film & Developer
Tri-X, Pyrocat HD 2:2:100
Paper & Developer
Adox MCC 111, Sprint QSPD
Thanks fellows! It's hard to make a decision based on the printing of 3 negatives but so far I am VERY impressed with this VC paper. Chis, you're correct. I had printed some of these on graded paper but wasn't happy with the results. More so than VC vs Graded, I think I'm simply a better printer than I was two years ago. At least I hope so! Thanks. Shawn
 
Amazing, Shawn. A great series of photographs from Zabriskie.
- Thomas
 
I like this one
 

Media information

Category
Standard Gallery
Added by
Shawn Dougherty
Date added
View count
1,112
Comment count
18
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
zpointmcc111.jpg
File size
112.1 KB
Date taken
Sun, 13 July 2008 11:41 PM
Dimensions
500px x 395px

Share this media

Cookies are required to use this site. You must accept them to continue using the site. Learn more…