Rollei E36 Charger Repair

Discussion in 'Camera Building, Repairs & Modification' started by ic-racer, Aug 17, 2010.

  1. ic-racer

    ic-racer Member

    Feb 25, 2007
    Midwest USA
    Multi Format
    I have a few E36 flash chargers (its the one for the 'potato masher' flash if you are not familiar with the numbers).

    One went bad today. A little inspection shows that there is a thermal cutoff component that is open circuit.

    Mine had a "Microtemp" 4191A which I believe is a 91 degree Centigrade cutoff. These one-shot items. So it needs to be replaced if it ever over heats.

    Here is the PDF (

    So....if your E36 charger is not working, check inside to see if the Microtemp TCO has gone into open circuit.

    If the Microtemp brand component is difficult to find I think this competitor from will work:
    Last edited by a moderator: Aug 17, 2010