phc
Allowing Ads
Hi folks,
Since the un-deved films are piling up on my desk (about 200 now), I've taken the plunge and I'm now the proud owner of a Jobo ATL-1000. This means, of course, that all the times that I've been using for developing must be re-learnt. So I'm asking for some clues!
I use 400TX at 400 and 1600, Plus-X at 125 and TMZ at 3200. My standard dev will be HC-110B. I usually dev at 20degC.
Any ideas at how long I should set the machine to dev as a first attempt on a test roll? I was using 7-8min in a hand tank, despite Kodak's sub-4 minute claim!
Thanks, Paul.
Since the un-deved films are piling up on my desk (about 200 now), I've taken the plunge and I'm now the proud owner of a Jobo ATL-1000. This means, of course, that all the times that I've been using for developing must be re-learnt. So I'm asking for some clues!
I use 400TX at 400 and 1600, Plus-X at 125 and TMZ at 3200. My standard dev will be HC-110B. I usually dev at 20degC.
Any ideas at how long I should set the machine to dev as a first attempt on a test roll? I was using 7-8min in a hand tank, despite Kodak's sub-4 minute claim!
Thanks, Paul.
