'Allo. I've decided I want to build a large camera obscura and make a 6 month solargraph with it. It's going to be pretty expensive to construct but after talking with a few teachers at school today I'm positive I can get a grant of at least $500. Obviously, before I request a grant I need to know what the hell I'm doing. xD Here are the specifications thus far. Please let me know if any of my calculations are horribly wrong or if I've left something out. The camera will be 12' x 8' x 6'. The back 12' x 8' wall will be covered with approximately 100 sheets of 11" x 14" B&W photo paper. The pinhole diameter will be 1.9mm and will be placed in the center of the front wall, 6 feet away from the back wall. The base of the camera will be constructed according to this how-to article: http://www.outdoorlife.com/articles/joseph-truini/2007/09/build-portable-platform The 4 sides of the camera will be standard wooden stud walls and will be arranged at one end of the wooden platform. The front wall will have a door positioned on the right side of the pinhole. 3 additional wooden stud walls will be placed in a square formation around the door (one of which also having a door) to create a foyer so one can enter the camera obscura to collect the film at the end of the exposure without exposing the paper to light. The roof of the camera will be made of plywood and positioned at a slight angle (the front wall will actually be a few inches taller than 8 feet to make this possible) to allow rain to roll off towards the back. After the construction of the camera, the sheets of 11" x 14" photo paper will be adhered to the back wall with the aid of a dim safelight. After exposure, the photo paper will be taken down from the wall, placed in a light-tight box, and immediately scanned into the computer where each of the 100 pieces will be inverted, adjusted, and stitched together. That's what I have so far. The only things I can think of that I haven't yet decided on are what kind of doors to use and how exactly the wall pieces will be attached to the base and each other (I'd like to find a way to construct it so that the camera can be disassembled and reassembled later with relative ease.) Once again, let me know if any of my measurements are wrong or if I've left anything else. Any tips and warnings/cautions would also be incredibly beneficial and very much appreciated.