a Deardorff back? It seems my used 5x7 reducing back has been dropped or banged a bit and two pins are flush with the surface. No way can I get a grip on them without removing some of the surrounding wood. Any ideas on how to get a grip? Are these pins threaded for insertion? Or just pressed in? Thanks for any help with this puzzle!
Any suggestions on fixing the pins on
-
A
- Thread starter Sandman
- Start date
Recent Classifieds
-
For Sale Arca Swiss Lens Extension Box (Top Hat) 141mm - $275
- Started by berarthbun
-
For Sale 5x7 Arca Swiss Conversion Kit 141mm Front Frame - Four 5x7 Holders - $2,600
- Started by berarthbun
-
For Sale 8x10 Arca Swiss F-Metric With Micro-Orbix Tilt - $5,800 Read For Details
- Started by berarthbun
-
For Sale FS: Canon 24mm Tilt Shift vII
- Started by dirkfletcher
-
For Sale FS: Mamiya ProSD 6x7 120 Roll Film Holder
- Started by B.S.Kumar
Forum statistics
Sandman
these pins are usually pressed or driven in. You may have to remove some of the surrounding wood to get ahold of the pin with a needlenose plier. After rmoving them you can insert a dowel into the remaining hole & reinsert the pin. A pilot hole would prevent you from cracking the frame.
these pins are usually pressed or driven in. You may have to remove some of the surrounding wood to get ahold of the pin with a needlenose plier. After rmoving them you can insert a dowel into the remaining hole & reinsert the pin. A pilot hole would prevent you from cracking the frame.
| Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links. To read our full affiliate disclosure statement please click Here. |
PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:  |