Another unicolor question

Recent Classifieds

Forum statistics

Threads
178,700
Messages
2,458,275
Members
94,614
Latest member
Martin C
Recent bookmarks
0

mark

Member
Joined
Nov 13, 2003
Messages
5,686
probably a dumb question.

Thanks to Brian I have another unicolor tank that I will try to use to develope with. Hopefully this will take care of the scratches I get with tubes the hassel of tray processing. I was reading the instruction and they say to roll the things very forcefully. This does not make since. Do I really knock it off it's base "Smartly" and roll it back and forth smartly as well?

Am I right in assuming I should roll it back and forth steadily and not "smartley"?
 

bobfowler

Subscriber
Joined
Sep 18, 2003
Messages
1,441
Location
New Jersey,
Shooter
Multi Format
I would get a uniroller or beseler motor base ASAP. Your arms are going to get mighty tired rolling that drum back 'n forth. :smile:
 
OP
OP

mark

Member
Joined
Nov 13, 2003
Messages
5,686
I keep getting out bid on the rollers, but I am patient. So yes I will be doing it by hand. I figure it will be no different than bobbing tubes in a tub.

Brian,
Your right about it being for prints. I was just clarifying, because I am real damn tired of killing negatives.

Viva la unicolor (at least I hope)
 

Konical

Subscriber
Joined
Jun 1, 2003
Messages
1,820
Good Afternoon, Mark,

Keep trying on the motor base. I recently purchased one on E-Bay for about $15.00.

Konical
 

photomc

Member
Joined
Jul 20, 2003
Messages
3,575
Location
Texas
Shooter
Multi Format
Mark, read somewhere recently where someone took 4 of the plastic disk used to move furniture and placed on some wood in a V formation as an aid to rolling by hand. Might make it easier, though not a motor base. Was lucky and got one with 3 tubes for $25 at a camera show a couple of years ago...my problem was with the negatives moving around and overlapping..went back to trays...been looking at the Summitek (sp?) cradle.
 
OP
OP

mark

Member
Joined
Nov 13, 2003
Messages
5,686
Somewhere around here, someone had the idea of splitting some small plastic pipe. I tried it, slipped in four of my many screwed up negatives with these split pipe spacers (they clamp over the ridges real well) and shook the bageeses out of the tube while watching TV. nothing over lapped and the pipe did not come off. I put water in it and did the same thing. No leaks and no slippage. Took about two minutes to cut the little tubes. My hopes are up.

I am still trying for the rollers but until then hand rolling on the table is fine. the V thing sounds interesting but I would need to see one. I can't figure out how it would work.
 

bobfowler

Subscriber
Joined
Sep 18, 2003
Messages
1,441
Location
New Jersey,
Shooter
Multi Format
Help is on the way!

This thread on photo.net has pictures of the elusive spacer for unicolor drums to keep multiple 4X5 prints/negatives apart during processing. I made mine from a piece of rubber scavenged from a snare drum practice pad (long story). A couple of the pix have a ruler included for scale, so it's not hard to make one.
 
Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links.
To read our full affiliate disclosure statement please click Here.

PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:



Ilford ADOX Freestyle Photographic Stearman Press Weldon Color Lab
Top Bottom