Recent content by LIK

Solved the problem. One of the screws clamped the wires and broke the insulation on the M sensor

There are clearly no problems with lighting. I have both the seals and the frame installed. I'll see what the problem is. Thanks

There are clearly no problems with lighting. I have both the seals and the frame installed. I'll see what the problem is. Thanks

Before that, there were no special problems and this error did not occur.

Hi. I recently encountered this error. I don't understand why it appeared. What does it mean and what are its reasons?

And regarding the fact that the sensors read the same value in different ways - Everything is cool. Everything is fine with the new firmware version. This problem is no longer there

Regarding that error in the scheme. Everything is simple. The output of the encoder and buttons are not connected to GND. The fix is very simple

I'm finally done. It took me 7 days to make my own portable mini version of the tester. Special thanks to Niglyn. What you did is a very cool and necessary thing. I am glad that you are still working on the tester and improving it. A real hero for analog photography in the field of repair. And...

I checked the new firmware and the problem with the 2nd sensor seems to be gone🙂

Okay, then I'll wait for your new firmware and see what the problem might be. Maybe I somehow hooked the wire and its output contact is constantly working

The building is beautiful. I also like the main thing is not to look at what's inside 🤣 I also "cleaned up" the wires😁

This error did not appear on V3 version, it seems, it appeared only in V4 version.

The assembly was almost completed. It remains to finish a little and solve this error. By the way, I found one error in the connection diagram V4. When I'm done, I'll tell you where to fix it

Hi. Can you tell me what the problem might be? Sometimes this error pops up, but not every time. I didn't see any pattern in it. That is, for example, I do 3 tests and everything is fine. I do not change anything and do the 4th test and for some reason an error comes out

Hi. Could you give me the access key to V4? I put on an enconder today and forgot to ask for the key in advance