Recent content by Hozu

Thanks, I will think about this over some sleep and see if It's worth doing it or not. I really hoped it could be a straightforward job, but to pinpoint where its from makes it even more difficult! I might alternatively just get a repairman do a CLA that I found just now that's not asking for a...

It squeaks even with film inside it

I don't feel like its from the top cover to be honest. It feels like I can hear it either from the bottom cover or inside. I think this video gives a better audio of it. You can hear a very loud whine noise. Also to point out when the camera is set to film rewind and I move the film advance...

I figured on a video it would be difficult, but in person it’s very obvious. i took the camera apart to look into it, but for the love of me I can tell which part it would be even when I did advance it. And no, it’s all the same. With film or without. I tried to get a quote to fix it and one...

Hello! I’ve recently purchased a Canon P although with two issues… The most annoying one and main on is a squeaky shutter advancement that happens when you advance the frame. When I confronted the seller he told me while he ”did” CLA he didnt touch anything that was working, but at the same...

thank you, much appreciated! I will definitely come back with an update once I finish the second roll so hopefully anyone using the same developer can find use the times too! should probably think of uploading it to massive dev if it works out

did look around and found that someone developed Rollei 80S in 9 minutes so if I do the calculation it would possibly be around 7-7:30? That sounds reasonable, will try this with my second roll!

Aha, yeah that does look like it. I will probably go down in development time by 7:30? Or just 7minutes, not too sure but the 8:30 dev time was a estimate after some research since there's no data for this dev + HR-50.

So I've taken a guess on the development time and went with 8:30 which yielded some result (surprisingly! I was expecting it to fail) The developer came out in a very peculiar colour that I haven't seen it go before, normally it's clear or ever so slightly yellowish but this time it came out...

Hello! I didn't realise there actually is a section like this here so might as well! I've dropped deep into the rabbit hole of photography since March 2024 without any prior knowledge in photography at all so I had to learn quite a lot! In the little short time I think I had the biggest...

did a bit of more sleepless research and will probably do a snip test before developing my film and pretty much pray/hope it will be close enough to my assumed 8 minutes? I will definitely get back here with a developed negative and see if people think it’s overdeveloped or underdeveloped...

I have the mobile app and I’ve been using it very often, but unfortunately there’s no time for it as well. the only ones are the ones I’ve attached

To be honest I thought of the same 😅 but I really wanted to challenge myself somehow if possible. Ive never shot any of Adox film or ISO below 100 before and I really wanted to try something “new” to me.

thank you! Apologies I’ve just added it! Should’ve thought about this earlier!

Sorry, should’ve made it clear that my question is aimed only at Adox HR-50. the other ones were nothing but an example of times and they’re already times within the data sheet of the developer.