I developped 6 Acros 100 as follows in Jobo Tank : (all chemicals were fresh) I put 2-120 films on 1 spiral (Jobo) temperature 20 grad Celsius rotation with Heiland TAS prozessor 1. pre-wetting 3 min in Distilled water 2. Development in XTOL 1+1 for 12:30 min (prepared with distilled water) 3. Stopper 30 sec 4. Fixer 5 min 5. Washing 15 min 6. Tetenal Mirasol 1 min (2 ml for 1 l of water) 7. hanged + dried films with paper tissue 8. wait until completely dry The films have the following problem with spots/streaks as you can notice on the attached pictures. Air bubbles ? The day after I processed 3x135 Acros films using the same procedure and I have no problem with the negs. Any feedback is welcome ?