Ok, so I mixed up one batch of caffenol-C and it went terribly wrong from the get go. so bad that I scrapped that batch and started over before I began. I followed the instructions off of the digitatruth site and mixed it up in the kitchen sink. I tried to keep the temp at a constant 20*c for 15min and did three rinses for a stop bath and fixed with Ilford @ 1:4 for 5min. After another 5min rinse I took the film out and it was totally blank. Blank as a stare from a a cow to slaughter. There might possibly be faint latent images on the film but I don't think that the best FBI lab could pull anything off of it. The recipe that I used was: 8oz (300cc) water 2-1/2 tsp Arm and Hammer soda 1 ml of Fruit-Fresh ( active ingredients: Dextrose, Ascorbic Acid, Citric Acid, Silicon Dioxide (anti caking), contains no sulfates). The vitamin C is 230% 4 tsp of "Great Value 100% Arabica Premium Instant Coffee. This is not a terrible loss even though I would like to have gotten some kind of positive results (pun intended). What could I have done different to come to the results that I was hoping for? I won't even bother to ask what I did wrong because there are just to many variables that I may not have listed or done or the stars were in the wrong alignment or maybe I didn't hold my tongue the correct way. I will still keep trying but I want to do it right. I probably should have used something other than the Fruit-Fresh. Edit: After allowing the film to dry the emulsion side is tacky to the touch and can be rubbed off. Hmmmmm.